a small screwdriver until the amber light starts to flash slowly. Release the switch.
The amber light will flash slowly a total of sixteen times and then stop. This
indicates that the Repeater mode has been re-activated.
11. RadioLINK ACCESSORIES
Ei411H - RadioLINK REMOTE SYSTEM CONTROL
This wall mounted device allows you to Locate, Hush and Test
RadioLINK Bases with Ei161RC, 164RC or 166RC only alarms
fitted. It also has a Locate Memory function that allows the alarm that
had previously triggered the system to be identified - a useful
troubleshooting feature.(This device must not be used with Ei141,
Ei144 & Ei146 alarms attached to Ei168RC Bases).
Ei428 - RadioLINK RELAY MODULE
This module is a device that switches an internal relay upon receipt
of an alarm signal from a RadioLINK device - useful for signalling
to panels, turning on strobes etc.
Ei407 - RadioLINK MANUAL CALL POINT
This wall mounted call point, when activated, will alarm all
Smoke/Heat Alarms mounted on Ei168RC RadioLINK Bases.
21
To Next Page
Loading...
