Why thermostat switches EINHELL Water Pump off?
If the thermostat switches off your EINHELL Water Pump, it could be due to: * An overloaded motor. If this is the case, dismantle and clean the pump. * Excessive friction caused by foreign substances. To solve this, prevent the intake of foreign substances by using a filter.
Why EINHELL 41.803.50 motor fails to start up?
If the EINHELL Water Pump motor fails to start, the possible causes are: * There is no mains voltage. In this case, check the voltage. * The pump rotor is blocked. If this is the case, dismantle and clean the pump.
What to do if EINHELL 41.803.50 Water Pump has no intake?
If your EINHELL Water Pump has no intake, here are several things to check: * Ensure the intake valve is immersed in water. * Fill water into the intake if the pump chamber lacks a water connection. * Make sure the intake line is airtight to prevent air leaks. * Clean the intake valve if it's leaking. * Clean the strainer if it's blocked. * Verify that the maximum suction height hasn't been exceeded.
What to do if EINHELL 41.803.50 Water Pump has inadequate delivery rate?
If your EINHELL Water Pump has an inadequate delivery rate, consider these potential causes: 1. The suction height is too high, so check the suction height. 2. The strainer is dirty, so clean the strainer. 3. The water level is falling rapidly, so immerse the intake valve deeper. 4. Pump performance is diminished by contaminant parts, so clean the pump and replace wearing parts.
General| Max. immersion depth | 7 m |
|---|---|
| Max. water temperature | 35 °C |
| Max. particle size | 5 mm |
| Power | 400 W |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Cable Length | 10 m |
To Next Page