Why is my EINHELL GE-SP 4390 N-A LL ECO Water Pump not pumping?
If your EINHELL Water Pump isn't pumping water, start by checking the intake sieve. If it's clogged, clean it with a water jet. Also, inspect the discharge hose to ensure it's not kinked. If it is, unkink the hose to allow proper water flow.
What to do if EINHELL GE-SP 4390 N-A LL ECO has insufficient pumping rate?
If your EINHELL Water Pump's pumping rate is insufficient, the intake sieve may be clogged. Clean the intake sieve to resolve this. Additionally, heavily contaminated or abrasive water impurities can reduce performance. In this case, clean the equipment and replace any worn parts.
What to do if my EINHELL GE-SP 4390 N-A LL ECO Water Pump switches off after briefly running?
If your EINHELL Water Pump switches off shortly after starting, it could be due to a couple of reasons. First, the motor circuit-breaker might be activating because of excessive water contamination; in this case, unplug the power and clean the equipment and shaft. Second, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Make sure the water temperature doesn't exceed 35 °C.
How to troubleshoot EINHELL Water Pump that does not start?
If your EINHELL Water Pump isn't starting, begin by checking the power supply to ensure it's properly connected. Also, check the autostart level and ensure it is in the correct position.
General| Max Pressure | 0.9 bar |
|---|---|
| Max Suction Depth | 8 m |
| Max. delivery height | 9 m |
| Max. immersion depth | 7 m |
| Max. water temperature | 35 °C |
| Max. size of foreign particles | 5 mm |
| Mains supply | 230 V |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Cable Length | 10 m |
| Max Head | 9 m |
| Max Flow Rate | 9000 L/h |
| Power cable | 10 m |
To Next Page
