EINHELL 41.704.45 - User Manual

Questions and Answers

D
Danielle BerryAug 7, 2025
Why does my EINHELL Water Pump switch off after briefly running?
- T
  Terry SotoAug 7, 2025
  Your EINHELL Water Pump might be switching off shortly after starting due to a couple of reasons: * The motor circuit-breaker might be tripping because of excessive water contamination. If this is the case, unplug the power and clean the equipment and shaft. * Alternatively, the water temperature may be too high, causing the motor circuit-breaker to switch off the equipment. Ensure that the water temperature does not exceed 35 °C.
M
Mike JacksonAug 12, 2025
What to do if my EINHELL Water Pump does not start?
- C
  Christopher CastilloAug 12, 2025
  If your EINHELL Water Pump doesn't start, there are a couple of things you can check: * First, make sure the power supply is properly connected. * Second, check the floating switch. If it's not triggering, raise its position.
T
Trevor FloresAug 19, 2025
What to do if my EINHELL 41.704.45 does not pump water?
- R
  Rose SheltonSep 12, 2025
  If your EINHELL Water Pump isn't pumping water, it could be due to a couple of issues: * The intake sieve might be clogged. If so, clean it with a water jet. * The discharge hose could be kinked. Straighten the hose to remove any kinks.
K
Karen CowanAug 25, 2025
Why EINHELL 41.704.45 has insufficient pumping rate?
- A
  amanda38Aug 26, 2025
  An insufficient pumping rate in your EINHELL Water Pump can occur due to: * A clogged intake sieve. Clean the intake sieve. * Reduced performance caused by heavily contaminated and abrasive water impurities. Clean the equipment and replace any worn parts.
M
michaelparsonsAug 31, 2025
What to do if my EINHELL Water Pump does not cut out?
- J
  Joseph FoxAug 31, 2025
  If your EINHELL Water Pump isn't cutting out, it might be because the floating switch can't sink. Ensure the equipment is correctly placed on the shaft bottom.

Summary

Safety Regulations

Proper Use

Technical Data

Before Starting the Equipment

Installation

Details on how the equipment can be installed, stationary with rigid or flexible hose.

Mains Connection

Information on connecting the equipment to the power supply and necessary safety measures.

Operation

Setting the On;Off Switching Point

Instructions for adjusting the floating switch to control automatic pump operation.

Manual Mode;Shallow Water

Guidance on using the pump manually or for shallow water suction operations.

Replacing the Power Cable

Cleaning, Maintenance and Ordering of Spare Parts

Cleaning the Paddle Wheel

Step-by-step guide for dismantling and cleaning the paddle wheel component.

Maintenance

Notes on internal maintenance, stating no parts inside require additional care.

Ordering Replacement Parts

Specifies the necessary data to provide when ordering spare parts.

Disposal and Recycling

Storage

Troubleshooting Guide

Service Information

Warranty Certificate

EINHELL 41.704.45 Specifications

General

Max. delivery height	9 m
Max. immersion depth	7 m
Max. water temperature	35 °C
Max. particle size	5 mm
Power cord length	10 m
Voltage	230 V
Frequency	50 Hz
Hose connection	47.8 mm (G1 1/2 IG)
Max Flow Rate	15000 l/h
Inlet/Outlet Diameter	47.8 mm