GB
- 16 -
10. Troubleshooting
If the equipment is operated properly you should experience no problems with malfunctions or faults.
In the event of any malfunctions or faults, please check the following before you contact your customer
services.
Fault Possible cause Remedy
Equipment does not
charge up
- Charger clamps connected incor-
rectly
- Contact between the charger
clamps
- Battery defective
- Wrong charging voltage selected
- Connect the red clamp to the posi-
tive pole and the back clamp to the
bodywork
- Prevent contact
- Have the battery checked by an
expert and replace it if necessary
- Select the right charging voltage for
the connected battery
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers
accompanying products is permitted only with the express consent of the iSC GmbH.
Subject to technical changes
Anl_CE_BC_1_M_SPK9.indb 16Anl_CE_BC_1_M_SPK9.indb 16 14.03.2019 06:30:2014.03.2019 06:30:20
To Next Page
Loading...
Need help?
General
