What to do if my EINHELL CE-BC 2 M does not charge up?
If your EINHELL Battery Charger isn't charging, first ensure the red clamp is connected to the positive pole and the black clamp to the vehicle's bodywork. Also, make sure the charger clamps aren't touching each other to prevent contact. If the issue persists, the battery may be defective and should be checked by an expert, replacing it if necessary.
What to do if the EINHELL Battery Charger clamps are in contact?
If your EINHELL Battery Charger is not charging, it might be due to contact between the charger clamps. Make sure to prevent any contact between the clamps.
Explains how to select and adjust the charging functions using the Mode button.
Details the steps for connecting and safely charging the battery.
Explains the conditions under which the error LED will light up or flash.
Details the steps required to safely disconnect the charger after the battery is fully charged.
General| Power plug | - |
|---|---|
| Display type | LED |
| Mounting type | Freestanding |
| Product color | Black, Red |
| AC input voltage | 220-240 V |
| Built-in display | Yes |
| Charging current | 1/2 A |
| Charging voltage | 12 V |
| AC input frequency | 50 Hz |
| Power protection features | Overcharge, Short circuit |
| International Protection (IP) code | IP65 |
Weight and Dimensions| Depth | 148 mm |
|---|---|
| Width | 70 mm |
| Height | 250 mm |
| Weight | 308 g |
| Package weight | 500 g |
To Next Page