EINHELL CE-CC 18 Li - Resolving Compressor Issues; Troubleshooting Common Problems

GB
- 22 -
11. Troubleshooting
Fault Possible cause Remedy
The compressor
does not start up
- The battery is empty
- The device is not switched on
- The set pressure is too low
- The On/Off /Automatic switch (Fig.
1 / Item 7) is not pressed
- Charge the battery
- Press the button Fig. 7 / Item 9b
- Set a higher pressure
- Press the On/Off /Automatic switch
The compressor
does not switch off
- Press the “Manual” switch - To switch off , let go of the switchn
The pressure is set
but the compressor
does not switch off
at the set value
- The “Manual” switch (Fig. 6 / Item 7b)
is pressed
- To switch off , let go of the switch
- For automatic mode see section
6.4. point a)
Anl_CE_CC_18_Li-Solo_SPK13.indb 22Anl_CE_CC_18_Li-Solo_SPK13.indb 22 19.05.2021 12:28:2019.05.2021 12:28:20