What to do if my EINHELL GC-GP 6040 ECO has no intake?
If your EINHELL Water Pump has no intake, ensure the intake valve is fully immersed in water. Check that the pump chamber is properly connected to water and filled. Make sure the intake line is airtight. Clean the intake valve and strainer to remove any blockages. Verify that the suction height does not exceed the maximum limit.
Why does my EINHELL Water Pump motor fail to start up?
If your EINHELL Water Pump's motor fails to start, first check that there is mains voltage. If voltage is present, the pump rotor might be blocked. In this case, dismantle and clean the pump.
Why is the delivery rate of my EINHELL GC-GP 6040 ECO Water Pump inadequate?
If the delivery rate of your EINHELL Water Pump is inadequate, check the suction height as it might be too high. Also, a dirty strainer can cause this issue, so clean it thoroughly. If the water level is falling rapidly, immerse the intake valve deeper. Contaminants can also diminish pump performance; in this case, clean the pump and replace any worn parts.
What to do if thermostat switches EINHELL Water Pump off?
If the thermostat switches off your EINHELL Water Pump, it could be due to the motor being overloaded. Dismantle and clean the pump to resolve this. High friction from foreign substances can also cause this; prevent their intake by using a filter.
General| Power | 600 W |
|---|---|
| Max Flow Rate | 4000 l/h |
| Max Pressure | 4 bar |
| Suction Height | 8 m |
| Delivery Height | 40 m |
| Max. water temperature | 35 °C |
| Water fill plug | Yes |
| Drainage screw | Yes |
| Mains supply | 230 V |
| Voltage | 230 V |
| Frequency | 50 Hz |
| Inlet/Outlet Diameter | 1" |
| Suction connection | 33.3 mm (R1 AG) |
| Pressure connection | 33.3 mm (R1 AG) |
To Next Page