8.4.4 Adjust the scale
Every scale on the crosscut and miter saw should be
checked and adjusted if necessary.
앬 Undo all the fastening screws for the scales.
앬 Adjust the saw precisely to an angle dimension,
realign the angle scales and tighten the screws
again.
Check the settings by completing test cuts.
8.4.5 Adjust the splitter
The splitter can be adjusted as shown in Fig. 69. The
dimensions shown in graphic 46 must be obeyed for
this purpose.
9. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
앬 Type of machine
앬 Article number of the machine
앬 Identification number of the machine
앬 Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
31
GB
To Next Page
Loading...
