EINHELL TC-SY 600 S User Manual

GB
- 27 -
12. Troubleshooting Guide
Problem Possible Cause Solution
No material exits
from the nozzle
Nozzle clogged
Material tube clogged
Max. paint volume control rotated too far
anti-clockwise (-).
Material tube is loose.
No pressure build-up in the container.
Consistency of the material is too thick.
Clean
Clean
Turn clockwise (+)
Insert
Tighten container
Dilute
Material drips from
nozzle after spray-
ing
Nozzle is loose.
Nozzle is worn.
Nozzle seal is worn.
Solids in the air cap or nozzle.
Tighten
Replace
Replace
Clean
Atomization too
coarse
Material viscosity too high
Material volume too high
Max. paint volume control turned too far
clockwise (+).
Dirty nozzle.
Insuffi cient pressure build-up in the con-
tainer
Dilute
Turn the max. paint volume con-
trol anti-clockwise (-)
Clean
Tighten the container
Intermittent („fl utte-
ring“) spray
Almost all of the material in the container
has been used up.
Add more
Coating pattern is
too light and uneven
You moved the paint spray gun too fast ac-
ross the surface you are working on.
Move the gun more slowly.
The paint runs or
sags.
You applied too much material. Turn the max. paint volume con-
trol anti-clockwise (-)
Excessive spray
mist
The gun is held too far away from the object
you are working on.
Hold the gun closer.
Turn the max. paint volume con-
trol anti-clockwise (-)
Anl_TC_SY_600_700_SPK9.indb 27Anl_TC_SY_600_700_SPK9.indb 27 16.07.2018 16:56:2416.07.2018 16:56:24

EINHELL TC-SY 600 S Specifications

General

Capacity	0.8 L
Hose length	1.8 m
Product color	Black, Red
Adjustable strap	Yes
Spray gun purpose	Paint
AC input voltage	220-240 V
AC input frequency	50 Hz
Package depth	480 mm
Package width	570 mm
Package height	285 mm
Package weight	4050 g

Weight and Dimensions

Weight	3050 g