GB
- 65 -
allow people who are not familiar with the tool or who have not
read these instructions to use the tool. Electric tools are dange-
rous if they are used by inexperienced people.
42. Keep your cutting tools sharp and clean. Carefully maintained
cutting tools with sharp cutting edges will jam less and are easier
to control.
43. Have your tool repaired only by trained personnel using only
genuine spare parts. This will ensure that your tool remains safe
to use.
44. All covers and safety devices have to be properly fi tted before
the equipment is switched on.
45. When working with wood that has been processed before,
watch out for foreign bodies such as nails or screws etc.
46. Before you actuate the On/Off switch, make sure that the saw
blade is correctly fi tted and that the equipment‘s moving parts
run smoothly.
47. Keep handles dry, clean and free from oil and grease.
Keep this safety information in a safe place!
2. Layout and items supplied
2.1 Layout (Fig. 1-26)
1. Saw table
2. Saw blade guard
3. Push stick
4. Blade
5. Splitter
6. Table insert
7. Parallel stop
8. Hand wheel
9. Locking grip for saw blade angle
10. Crank arm
11. On/Off switch
12. Eccentric lever
Anl_TC_TS_2000_U_SPK9.indb 65Anl_TC_TS_2000_U_SPK9.indb 65 28.04.2020 14:40:0928.04.2020 14:40:09
To Next Page
Loading...
