EINHELL TC-TS 2000 U - Page 68

GB
- 68 -
•
Cross stop
•
Screw for parallel stop (2x)
•
Stop rail for parallel stop
•
Knurled screw for parallel stop (2x)
•
Leg (4x)
•
Cross strut (4x)
•
Strut for table width extension (left) (2x)
•
Strut for table length extension (right) (2x)
•
Table width extension (left)
•
Table width extension (right)
•
Additional leg (2x)
•
Wrench, size 10/13 mm
•
Wrench, size 10 mm
•
Hex screw (8x)
•
Washer, large (8x)
•
Lock bolt (8x)
•
Washer, small (20x)
•
Spring washer (8x)
•
Nut (20x)
•
Screw with washer and spring washer (12x)
•
Additional saw blade
•
Original operating instructions
•
Safety information
3. Proper use
The bench-type circular saw is designed for the slitting and cross-
cutting (only with the cross stop) of all types of timber commensu-
rate with the machine‘s size. The equipment is not to be used for
cutting any type of round wood.
The equipment is to be used only for its prescribed purpose. Any
other use is deemed to be a case of misuse. The user / operator
and not the manufacturer will be liable for any damage or injuries of
Anl_TC_TS_2000_U_SPK9.indb 68Anl_TC_TS_2000_U_SPK9.indb 68 28.04.2020 14:40:0928.04.2020 14:40:09