GB
- 83 -
10. Cleaning, maintenance and ordering of spare parts
Danger!
Always pull out the mains power plug before starting any cleaning
work.
10.1 Cleaning
•
Keep all safety devices, air vents and the motor housing free of
dirt and dust as far as possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low pressure.
•
We recommend that you clean the device immediately each time
you have finished using it.
•
Clean the equipment regularly with a moist cloth and some soft
soap. Do not use cleaning agents or solvents; these could attack
the plastic parts of the equipment. Ensure that no water can seep
into the device. The ingress of water into an electric tool increa-
ses the risk of an electric shock.
10.2 Carbon brushes
In case of excessive sparking, have the carbon brushes checked
only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep laced by anyone
but a qualifi ed electrician.
10.3 Maintenance
There are no parts inside the equipment which require additional
maintenance.
Anl_TC_TS_2000_U_SPK9.indb 83Anl_TC_TS_2000_U_SPK9.indb 83 28.04.2020 14:40:1028.04.2020 14:40:10
To Next Page
Loading...
