To Next PageTo Next Page
Need help?Do you have a question about the EINHELL TK 800 and is the answer not in the manual?
Instructions for attaching the table width extension to the saw table for increased capacity.
Step-by-step guide for installing or replacing the saw blade, including flange and direction checks.
Details on setting the splitter gap relative to the saw blade for safety and performance.
Procedure for attaching the saw blade guard to the splitter for user protection.
Steps to remove the old table insert and install a new one.
How to turn the machine on and off using the designated power buttons.
Detailed instructions on adjusting stop height, length, and width for precise cuts.
Guide to setting the blade's cutting depth using the hand crank and scale.
Instructions on how to tilt the saw blade to the desired angle using the hand crank.
Techniques for safely cutting workpieces less than 120 mm wide using the parallel stop.
Methods for cutting workpieces less than 30 mm wide using push blocks and sticks.
How to perform cuts at an angle to the work surface using the parallel stop.
Steps for making angled cuts at 45 degrees on small workpieces with mitre or cross stops.
Using the cross stop for precise crosscuts and length control on workpieces.
General