Eink MeeNote Evaluation Kit - How to Set VCOM & Temperature

15
(4) How to set VCOM & temperature
 Execute E_Ink_Tool_for_MeeNote_EVK_V5.0.1.4.exe (refer to Figure 3.7)
Set Vcom
1. Click “Engineer Features “button
2. VCOM Set/Get
3. Set/Get VCOM voltage value.
4. Click “Execute” button to Set/Get VCOM.
5. Click “OK” button
Set temperature
1. Click “Engineer Features “button
2. Temperature Set/Get
3. Set/Get temperature value.
4. Click “Execute” button to Set/Get temperature.
5. Click “OK” button
Figure 3.7
1
2
Vcom values are marked on the PCB label