EasyManua.ls Logo

EK EKS213-BT - Disc Operations and Features; Disc Preparation and Playback

Default Icon
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 8
DISC OPERATIONS
WARNING - Tapping or dropping the microphone while it is on can permanently damage your microphone.
Resist the urge to swing the microphone around by the cord!
PREPARATION
This unit is designed to play CDs bearing the
not play properly.
Fingerprints and dust should be carefully wiped off with a soft cloth. Wipe in a straight motion from the
centre of the disc to the outside edge.
Never use chemicals, such as record cleaning sprays, antistatic
clean compact discs. These chemicals will permanently damage the plastic surface of the disc.
Always place the compact disc on the disc tray with the label facing upward. Compact discs can be
played on only one side.
To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it
carefully by the edges.
Discs should be returned to their cases after use to protect them from dust and scratches.
To prevent warping the disc, do not expose it to direct sunlight, high humidity or high temperatures for
extended periods of time.
Do not apply paper or write anything on either side of the disc. The inks used in some felt-tip pens may
damage the surfaces of the disc.
TURNING ON/OFF
To turn on the unit, press the STANDBY button, the Standby Indicator will light to full brightness.
To turn it off, press the STANDBY button again, the Standby Indicator will light to half brightness.
LOADING A DISC
Lift up CD door to open CD/CDG compartment door. Place a disc in the compartment with the printed
side facing toward you.
Gently close the CD door to the CD/CDG compartment. The karaoke system begins to read the disc. After that,
press PLAY/ PAUSE to play the disc. (If no disc is loaded, it will display no”). (Refer to the Trouble Shooting
Guide on page 10 if a disc is loaded but the total tracks do not appear).
PLAY/PAUSE MODE
To start playing, press the PLAY/PAUSE 1 ] will be displayed on the LED display.
To temporarily stop playing, press the PLAY/PAUSE button.
To resume play, press this button again. PLEASE NOTE: Pressing pause when a CDG is playing may cause
distorted lyrics on the monitor. Any distortion will remain until the whole screen is refreshed during an
instrumental break or you stop the song and start it from the beginning.
PLAYING CD OR CD+G DISC
Adjust MASTER VOLUME control on your unit, TV or audio system to a comfortable level.
Adjust MIC VOLUME/A.V.C./ECHO/BALANCE controls as needed to achieve the desired mix of music
and vocals through your sound system.
Do not press the disc cover of the CD compartment while it’s playing.
Never place anything except a compact disc on the
disc tray. Foreign objects can damage the unit.
Do not apply excessive force to disc cover.
Only place one disc on the disc tray at a time.

Related product manuals