eka EKF 1016 E UD - Maintenance; Changing the Lighting Lamp in the Cooking Chamber; Changing the Door Seal

TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 22 _________________________________________________________________________________________
5
55
5.
..
. Ma
MaMa
Maintenance
intenanceintenance
intenance
5.1
5.1 5.1
5.1 General information
General informationGeneral information
General information
A periodic control (at least once a year) of the appliance aids to guarantee long life and correct
operations.
Any sort of maintenance work on the appliance must be done exclusively by technically
qualified operators who have been trained in the maintenance work on this appliance.
Before beginning any sort of maintenance work on the appliance, turn the power supply off (at
the magnetothermal safety switch upstream from the appliance) and let it cool down.
Access is gained to the inside components that could require maintenance work by removing
the left side of the appliance.
5.2
5.2 5.2
5.2 Changing the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamberChanging the lighting lamp in the cooking chamber
Changing the lighting lamp in the cooking chamber
The lamp is housed between the two door glasses; to replace it remove the external glass as
described in the paragraph: “Cleaning the door”.
Open the external glass, unscrew the 2 screws securing the lamp protection cover with the
appropriate tool and replace the lamp with another with the same specifications: 12V 35W
300°C (this is a halogen lamp and should not be touched with your bare hands).
5.3
5.3 5.3
5.3 Changing the door seal
Changing the door sealChanging the door seal
Changing the door seal
The door seal has a rigid profile with fixing tabs. The profile must be fitted into the guide on the
face of the cooking chamber.
To change the seal, remove the old one from the guide by pulling hard at the four corners.
Clean any dirt from the guide and introduce the new seal (to make this operation easier, we
advise dampening the seal profile with soapy water).