eka EKF 1016 E UD - Instructions for the installer

TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 6 _________________________________________________________________________________________
1.2
1.2 1.2
1.2 Technical rating plate
Technical rating plateTechnical rating plate
Technical rating plate
Tecnoeka S.r.l., Via
Marco Polo
, 1
1
35010 Borgoricco (Padova) ITALY
Model
:
E
EE
E
KF
KF KF
KF
1
11
1
11
1111
11
1
11
1
E
EE
E
UD
UDUD
UD
Voltage
:
380
-
400
V
3N
50
/60
Hz
Oven capac
ity
:
kW
15
Max
.
capacity
:
kW
16
Water pressure
:
kPa
1
5
0
520310727
Made in Italy
The Technical rating plate is
The Technical rating plate isThe Technical rating plate is
The Technical rating plate is fitted on the rear panel of the oven.
fitted on the rear panel of the oven.fitted on the rear panel of the oven.
fitted on the rear panel of the oven.
2
22
2.
..
. Instructions for the installer
Instructions for the installerInstructions for the installer
Instructions for the installer
The following instructions are addressed to the qualified installer to enable him to perform the
correct installation, electric and water connection operations in conformity with current safety
legislation in force in the place where the appliance is installed.
The manufacturer will not respond for damage to people, animals and property due to
installation errors. Likewise the manufacturer is not responsible for breakage caused to the
appliance by incorrect installation.
2.1
2.1 2.1
2.1 Storage
StorageStorage
Storage
If the appliance has been stored in a warehouse at a temperature below 0°C (min. allowed is –
10°C), it should be brought to a temperature of at least +10°C before it is turned on.
2.2
2.2 2.2
2.2 Transporting the oven
Transporting the ovenTransporting the oven
Transporting the oven
During transport, the appliance must be left in its original wooden cage to protect it against
damage.
2.3
2.3 2.3
2.3 Unpacking the oven
Unpacking the ovenUnpacking the oven
Unpacking the oven
Remove all the packaging before installation, which is formed of a wooden cage that holds the
appliance and cardboard casing to protect it. Check that the appliance has not been damaged
during transport and if any damage is discovered immediately inform your retailer and/or the
haulier.
2.4
2.4 2.4
2.4 Removing the protective film
Removing the protective filmRemoving the protective film
Removing the protective film
Before using the appliance, carefully remove the special protective film over the stainless steel
parts, without leaving any glue residue on the surfaces. If necessary, remove the residue at once
with a suitable non-inflammable solvent (e.g. acetone).
2.5
2.5 2.5
2.5 Disposing of the packaging
Disposing of the packagingDisposing of the packaging
Disposing of the packaging
The packaging must be disposed of in accordance with current legislation in force in the place
where the appliance is installed. The various types of materials (wood – paper – cardboard –
nylon – metal staples) used for the packaging must be separated and delivered to the specific
waste disposal centres. In all circumstances the environmental protection regulations must be
strictly adhered to.
SERIAL NO.
CERTIFICATION