eka EKF 1016 E UD - Possible Faults

Electronic Ovens rev. 0 __________________________________ EKF 1111 E UD – EKF 1064 E UD – EKF 1016 E UD
_________________________________________________________________________________________ page 23
5.
5.5.
5.4
44
4 Possible faults
Possible faultsPossible faults
Possible faults
Type o
Type oType o
Type of fault
f faultf fault
f fault Cause
CauseCause
Cause Corrective action
Corrective actionCorrective action
Corrective action
Control panel completely off
(the oven does not work)
- Incorrect electric connections to the
mains
- Check the mains connection
- No mains voltage - Restore mains voltage
- Thermal break safety device tripped - Reset the thermal break safety device
- Electronic card protection fuse (power)
burnt
- Contact a qualified technician
Cooking cycle set and START
push button pressed: the
oven does not work
- Door open or ajar - Close the door
- Damaged magnetic sensor
- Contact a qualified technician to repair
the sensor
Humidity Cycle/ steam
activated: no humidity/steam
is produced in the cooking
chamber
- Incorrect connection to water mains - Check the connection to water mains
- Cut-off cock closed - Check the cut-off cock
- Blocked water inlet filter - Clean the filter
- Damaged water inlet solenoid
- Contact a qualified technician to repair
the solenoid
Door closed: steam comes
out of the seal
- Seal not fitted correctly - Check the seal fitting
- Damaged seal
- Contact a qualified technician to repair
the seal
- Handle prong loosened
- Contact a qualified technician to repair
the prong
The oven does not cook
evenly
- One of the motors is blocked or turns
slowly
- Contact a qualified technician to repair
the motor
- The motors do not go into reverse
- Contact a qualified technician to repair
the motor
- Heating element not powered or is
damaged
- Contact a qualified technician to repair
the element
Lighting lamp in the cooking
chamber does not work
- Damaged lamp - Change the lamp
- Damaged lamp feeder
- Contact a qualified technician to repair
the feeder
The wording “Er1”
“Er1”“Er1”
“Er1” appears
on the temperature display
- Break in the connection between the
cooking chamber probe – electronic
(power) card
- Check the connection to the electronic
card
- Damaged cooking chamber probe
- Contact a qualified technician to repair
the probe