eka EKF 1016 E UD - Page 24

TECNOEKA Srl ______________________________________________________________ use and instruction manual
page 24 _________________________________________________________________________________________
Type of fault
Type of faultType of fault
Type of fault
Cause
CauseCause
Cause Corrective action
Corrective actionCorrective action
Corrective action
“Er3”
“Er3”“Er3”
“Er3”
is displayed on the temperature
display and an alarm is activated that can
be silenced by pressing the button.
Cooking can continue but it is necessary to
remove the cause of the fault causing the
electronic board to overheat.
- Cooling motor fan damaged
-
Contact a qualified
engineer to repair it
- Aeration openings present in the
metal walls blocked
- Unblock the openings
- Heat sources too near the oven
- Eliminate the
heat
sources
“Hot”
“Hot”“Hot”
“Hot” flashes on the temperature display.
The oven stops automatically and the alarm
is activated for 30 seconds.
The oven can be restarted only when the
electronic board has completely cooled
down
- Cooling motor fan damaged
- Contact a quali
fied
engineer to repair it
- Aeration openings present in the
metal walls blocked
- Unblock the openings
- Heat sources too near the oven
-
Eliminate the heat
sources
Core temperature activated and probe
connected to the control panel: the
message
“
““
“-
--
- -
--
- -
--
- “
““
“ appears on the temperature display
- Break in the connection between the
core probe – electronic (power) card
-
Check the connection to
the electronic card
- Damaged core needle probe
-
Contact a qualified
technician to repair the
probe