EKOM DK50 - Page 4

OPERATION MANUAL DK 50 4x2V/M
NP-DK50 4x2V-M-EN-16_11-2015 11/2015
4


2. ALERT NOTICES AND SYMBOLS
In the Installation, Operation and Maintenance Manual and on packaging and product, the following
labels or symbols are used for important information:
Information, instructions and cautions for the prevention of damage to health or
materials
Caution! Dangerous electrical voltage
Read the user manual!
CE mark of compliance
Compressor is remote-controlled and may start without warning
Caution! Hot surface
Earth (ground) connection
Terminal for ground connection
Fuse
Alternating current
Handling mark on package – FRAGILE
Handling mark on package – THIS SIDE UP
Handling mark on package – KEEP DRY
Handling mark on package – TEMPERATURE LIMITATIONS
Handling mark on package – LIMITED STACKING
Mark on package – RECYCLABLE MATERIAL
3. STORAGE AND TRANSPORT
The compressor is shipped in cardboard that protects the appliance from damage during transport.
Caution! For transport, always use the original packaging and secure the
compressor in the upright position.
Protect the compressor from humidity and extreme temperatures during transport and
storage. A compressor in its original packaging can be stored in a warm, dry and dust-free
area. Do not store near any chemical substances.
Keep packaging material if possible. If not, please dispose of the packaging material in an
environmentally friendly way and recycle if possible.
Caution! Before moving or transporting the compressor, release all the air pressure
from the tank and hoses and drain the condensed water.