1 5
T O R Q U E S E T T I N G S F O R S C R E W S
The hex-head screws holding either the panels or the base MUST be tightened with a
torque wrench (not included). TORQUE SETTING = 11 lbf-in. (12.7kgf-cm)*
* lbf-in = Pound Force Inches | kgf-cm = Kilogram Force Centimeters
CAUTION! DO NOT OVER TORQUE SCREWS AS THIS CAN CAUSE LEAKAGE ISSUES!
TO CONFIRM THE IP65 INTEGRITY AFTER A LAMP REPLACEMENT, TEST FIXTURE
USING THE ELATION IP TESTER. CONTACT ELATION SERVICE FOR MORE DETAILS.
To Next Page
Loading...
