elco THISION L PLUS - Connecting the Boiler

24
Installation
Connecting the boiler
1-2. Keep the cap on the connections
that are not used on the pipe work
headers:
Flow and return: 2" blind cap with
gasket (2 items/boiler).
Gas: 1 ¼" blind cap with gasket
(1 item/boiler).
For connections, use the supplied
gaskets. Check all connections for
leakage and gas-tightness.
3. Connecting the isolation valves to
the boiler:
Flow:2"atcouplingisolationvalve
with red handle.
Return:2"atcouplingttingcross
unionwithll/drainvalveand
isolation valve with blue handle.
The boiler is supplied with a 3 and
6 bar safety valve.
ELCOrecommendttingthe6
bar safety valve due to the control
settingsshuttingtheboilero󰀨at
6 bar.
Gas: 1¼" gas isolation valve.
Polluted test water may be
released when removing the
plastic caps on the boiler ow
and return.
For connections, use the
supplied gaskets. Check all
connections for leakage and
gas-tightness.
4. Connect the valves to the pipe work
headers:
Flow: 45mm pipe pieces with
2"atcoupling.
Return: 45mm pipe pieces with
2"atcoupling.
Gas:28mmpipepiecewith1¼"at
and28mmcompressiontting
For connections, use the
supplied gaskets. Check all
connections for leakage and
gas-tightness.
1
2
3
4