16.1 HIGH VOLTAGE PROBE HANDLES
A range of interchangeable high voltage probe
handles is available depending on the voltage
required. The Elcometer 266 is not supplied
with a probe handle, these must be ordered
separately.
For further information regarding connecting
and using a high voltage probe handle, see
Section 6 ‘High Voltage Probe Handle’ on
page en-11.
Description Voltage Part Number*
Elcometer 266 Probe Handle, DC5 0.5 - 5 kV T26620033-1
Elcometer 266 Probe Handle, DC15 0.5 - 15 kV T26620033-2
Elcometer 266 Probe Handle, DC30 0.5 - 30 kV T26620033-3
Elcometer 266 Probe Handle, DC30S 0.5 - 30 kV T26620033-4
(Continuous Voltage)
* Add ‘C’ to the end of the part number for a probe handle supplied complete with
calibration certificate.
Note: The DC30S Continuous Voltage Probe Handle is compatible with Elcometer 266
instruments with serial numbers ‘SC16119’ onwards. The software in older
instruments must be updated by Elcometer or your local Elcometer distributor to
recognise the new DC30S handle.
16.2 SECOND HAND GRIP
Ideal for testing pipes and tank floors with two
hands - without compromising safety.
For further information regarding the second
hand grip, see Section 13 on page en-23.
Description Part Number
Second Hand Grip T26620081
16 SPARES & ACCESSORIES
www.elcometer.com
en-27
R
To Next Page
Loading...
