EasyManua.ls Logo

elddis Aspire - High Pressure Gas Hoses; Electrical Control Panel

elddis Aspire
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9-2
HOW TO USE YOUR MOTORHOME’S EQUIPMENT
ELECTRICAL CONTROL PANEL
1 Button for control of car and leisure batteries
voltage (in Volt) and for the regolation of the
programmable parameters’ setting (see
SETTING).
2 Button for the control of drink water tank (in %),
for drinking water refilling function operation
(see “DRINK WATER TANK REFILLING”
function) and for the regolation of the
programmable parameters’ setting (see
SETTING).
3 “PROG” button for system setting (see
SETTING).
4 On/off main button (to turn on/off press for 2
seconds): at the start-up the display carries out
a functioning test and shows all symbols
(including unused symbols). If the relevant LED
is green the control panel is on, if it is red an
alarm is on (batteries, tanks, etc.).
5 Button to switch the lights on and off.
6 Button to switch the pump on and off.
7 Awning light button; this ext. light switches
automatically off when you start up the engine,
depends on the button rif.5.
NOTE: The watch is supplied from the leisure
battery (B2).
Should B2 be disconnected, the watch is able to
keep working, without visualisation, for about 2
weeks.
High Pressure Gas Hoses
You should only connect to this regulator
using a length of approved high-pressure
hose not exceeding 450mm from the gas
cylinder to the regulator. These approved
high-pressure hoses are available from your
Explorer Group Retailer. These hoses are
connected using screw thread fittings, which
will make a seal if connected and tightened
using a spanner. Once the hose is securely
connected turn on the gas tap above the
regulator, then turn on the gas bottle to allow
gas to flow into the motorhome.
In order to make all your motorhome gas
appliances operational it is necessary to
open each appliance gas tap as detailed in
previous column. All your gas appliances
should now be operational. Instructions on
how to use each appliance are detailed later
in your handbook.
CAUTION: It is strongly recommended that
only Gas Safe Register™ approved gas
fitters carry out any work on your
motorhomes gas installation..
WARNING: Aerosols and highly flammable
liquids must not be stored in the
compartment behind, or adjacent to, any
gas appliance. Some industrial LPG
appliances operate at high pressure and
require a ‘high pressure’ regulator. This
often has an adjusting handle on it.
NEVER use such a regulator on a
motorhome.
Ventilation holes must be clear at all
times.

Table of Contents

Related product manuals