9-8
HOW TO USE YOUR MOTORHOME’S EQUIPMENT
COOKING EQUIPMENT
WARNINGS
(i) All pans should be mounted centrally
over the burners, even when cooling,
to protect adjacent walls.
(ii) Do not lower the glass cover until hob
has cooled down.
(iii) Glass lids may shatter when heated.
Turn off all burners and grill before
shutting the lid. The glass cover
should be raised when operating the
grill.
(iv) Accessible parts may be hot when the
grill and oven are in use. Young
children should be kept away.
(v) Do not use grill or oven as a space
heater.
(vi) When you are cooking it is essential
to provide additional ventilation, such
as opening windows near grill, cooker
and oven.
Gas Hob
USING THE APPLIANCE
CAUTIONS
•Glass lids may shatter when heated.
Turn off all hotplates and allow to cool
before closing the glass lid.
• Remove all spillage from the surface
of the glass lid before opening.
• The glass lid has a tendency to snap
shut towards the end of lowering. This
4 burner hob
is caused by the travel lock action of
the hinges as it is activated. Make sure
all fingers are removed from appliance
when closing the lid.
• The appliance is not intended for use
by young children or infirm persons
without supervision.
•Young children should be supervised
to ensure that they do not play with
the appliance.
Electric Hotplate
Ensure the electricity is switched on.
The hotplate control is numbered from 1 to 6.
To turn it on, rotate the knob either clockwise
or anti-clockwise to the required position.
Position 1 is the coolest setting.
To turn the hotplate off, rotate the knob until
the line or pointer on the knob lines up with
the zero on the control panel.
The hotplate is a sealed construction and
transfers heat through conduction. For
maximum efficiency a correctly sized pan
with a flat heavy gauge base
should be used. Pan size should
be the same or slightly larger (up
to 1”/2.5cm oversize).
Before using your hotplate for the
first time, we recommend that you
prime and then season it.
To prime it, switch on the hotplate
for a short period, without a pan,
to harden and burn off the coating.
Use a medium to high setting for
3-5 minutes. A non toxic smoke
may occur during this process.
Allow it to cool, then season.
Control panel
To Next Page
Loading...
