9-32
HOW TO USE YOUR MOTORHOME’S EQUIPMENT
CAUTION: Avoid turning the spout by more
than 90 deg. as it may otherwise come loose
(fig 12).
6. Hold the cassette tank with one hand by
the handle (fig 13, 2). With the other
hand hold it at the blade handle (fig 13,
3) so that you can operate the vent
button (fig 13, 1) during emptying.
7. The vent button should only be pressed
once the emptying spout is pointing
downwards. The tank empties evenly and
without squirting.
8. After emptying, flush the cassette tank
thoroughly with water. Then make the
tank operational again as described in
section “Preparing cassette tank” before
inserting it in the toilet.
Fig 14
Exchanging the fuse on the control
panel
Lift the control panel with a suitable tool and
pull it out of the tank case or the wall (fig 14).
The fuse (automotive fuse 7.5A) is located on
the bottom side of the control panel.
Winter use
You can continue to use the cassette also in
winter, as long as the toilet and the cassette
are situated in a frost-protected location.
If this is not the case, empty the fresh water
tank, the cassette tank and the water pipes of
fresh water supply. This prevent damage due
to frost.
WARNING: Do not use anti-freeze agents.
Such agents can damage the sanitation
system.
Decommissioning
If you wish to decommission the toilet for long
periods of time, empty the fresh water tank
and the water supply system fully.
•Clean the toilet.
• Press the flush button until there is no
remaining water left in the pipes.
• Then empty the cassette tank and rinse it
thoroughly.
•To allow the tank to dry, do not place the
cap back on the emptying spout of the
waste tank.
Fig 12
Fig 13
To Next Page
Loading...