15
CONTINUOUS DRAINAGE
This dehumidifier has a continuous drain hole that can be connected to a plastic pipe
with a 15 mm inner diameter (Not Supplied). Water can be automatically plumbed in
or drained into a sink, a larger receptacle or through the wall into an outside drain.
Please follow the steps below to set your unit up for continuous drainage.
1. Cut off the cover for the continuous drain on the back of the unit.
2. Pull out the water tank and connect a water tube of inner diameter 15mm to
the drain connector, and ensure the connection is tight * Please note, the
water tube is not supplied with the unit.
3. Return the water tank back into position within the unit.
This unit uses gravity fall to dispose water hence the drain should be lower than the
dehumidifier water outlet. Be sure to run the water pipe downward and let the water
flow out smoothly. Do not kink or bend the pipe.
NOTES:
• When the continuous drain feature is not being used, reverse the pipe
installation, to start the water collecting in the water tank.
• The permanent drain can be used in conjunction with a water pump (e.g.
when draining from a cellar) to lift the water upwards.
To Next Page
Loading...
Need help?
General
