14
WATER DRAINAGE
When the water tank is full, the unit will stop automatically. When this happens the TANK
FULL red light will show on the control panel, and the unit will bleep.
There are two ways to dispense collected water. It can be either collected within the internal
tank or expelled through a drainage hose (not supplied) using continuous drainage.
USE THE TANK
When the tank is full, the unit will automatically stop running,
and the Tank Full indicator light will flash. Grip the tank by its
handle securely, and carefully pull out. Empty the water tank
and reinsert it into the dehumidifier. The tank must be in place
and securely seated for the dehumidifier to operate again. The
dehumidifier will re-start when the tank is restored to its correct
position.
NOTES:
• Do not remove the water tank immediately after the unit stops. Please wait a while
to avoid the water dripping into the unit and causing damage.
• Only empty the water tank when it is full or before moving or storing the unit.
• Do not rest the tank on the floor because the bottom of the tank could be uneven
and tank may fall and cause the water to spill.
• When you remove the tank, do not touch sensors or any parts which are situated
behind tank. Doing so may damage the product. Be sure to push the tank gently
all the way into the unit. Banging the bucket against anything or failing to push it
securely into place may cause the unit not to operate.
• Do not remove or damage the float switch in the water-tank, otherwise the
machine will stop working.
• Please make sure the water tank cover is put back into place correctly before the
water tank is reinserted.
• If the water-tank is inserted incorrectly, the tank full indicator will flash. Remove
the water tank and reinsert to turn the indicator off and resume normal use.
• At all times, avoid water entering the unit. It may cause an electrical hazard and
damage the unit.
To Next Page
Loading...
Need help?
General
