WIFI BUTTON
Press and hold the WIFI button for 3 seconds to activate the WIFI
connection mode. The WIFI indicator light will be illuminated. See the
WIFI guide within this manual for further information on how to set it
up.
HUMIDITY SETTING
Press the UP and DOWN buttons to select the desired relative
humidity level. The default relative humidity is 55%. When a relative
humidity of 35% is selected, the compressor will not stop until the
water tank is full.
NOTE: The desired humidity cannot be changed in SMART mode.
TIMER
Press the TIMER button to program the timer. When the timer is
activated, the "TIMER" light will illuminate. Before programming the
timer, ensure the timer function has not been activated (the light must
be off). The following timer programs are available.
DELAYED POWER-ON FUNCTION: With the appliance in standby,
press the TIMER button, then use the UP and DOWN buttons to set
in how many hours’ time you require the unit to start (0~24 hours).
DELAYED POWER-OFF FUNCTION: While the appliance is
running with the desired settings, press the TIMER button, then use
the UP and DOWN buttons to set in how many hours’ time you
require the unit to stop (0~24 hours).
INTELLIGENT DEFROST
The appliance will defrost automatically when the coil sensor detects
that the internal temperature is too low. During defrosting the
indicator will light up. Once the defrost cycle has finished, the
appliance will return to the mode that was previously operating.
TANK-FULL
When the water tank is full, the TANK FULL indicator light will flash,
and the unit will stop operating. Once emptied and replaced, the
appliance will resume operation.
OPERATION
The Operation light will illuminate when the compressor within the
unit is running to extract moisture from the air. Please note this may
not light up immediately when the unit is started, and will go out when
the desired humidity is reached.
HUMIDITY LEVEL & TIMER 2 DIGIT DISPLAY
The led indicator performs the following functions:
1 When the unit is plugged in, it will indicate the humidity level of the room.
2 When the UP and DOWN buttons are pressed, it will indicate the desired
humidity currently set.
3 When the timer is programmed will show the duration.
NOTES: When humidity level is outside the normal operational parameters will show
LO/HI. If ambient humidity is lower than 20%, it will show “LO” If ambient humidity is
higher than 90%, it will show “HI”. When HI/LO is displayed, the unit will not operate
until the humidity has returned to the normal range.
To Next Page
Loading...
Need help?
General
