P0 or P1 2880 Parameter
80 81 Push PLAY button
81 82 Mute/unmute track 1’s play**
82 83 Mute/unmute track 2’s play**
83 84 Mute/unmute track 3’s play**
84 85 Mute/unmute track 4’s play**
85 86 Push REC button
86 87 Select track 1 for record (or 1 and 2 if stereo)
87 88 Select track 2 for record (or 1 and 2 if stereo)
88 89 Select track 3 for record (or 3 and 4 if stereo)
89 90 Select track 4 for record (or 3 and 4 if stereo)
90 91 Push NEW button
91 92 Push QUANTIZE button
92 93 Push REC button
93 94 Push PLAY button
94 95 Push REVERSE button
95 96 Push TRACK SELECT button
96 97 Push STEREO button
97 98 Push PUNCH-IN button
98 99 Push EXT SYNC button
99 100 Push OCTAVE button
100 101 Push PLAY button
101 102 Mute/unmute track 1’s play**
102 103 Mute/unmute track 2’s play**
103 104 Mute/unmute track 3’s play**
104 105 Mute/unmute track 4’s play**
105 106 Push REC button
106 107 Push MIXDOWN button
107 108 Mute/unmute mix track’s play**
108 109 Mute/unmute Dry Out**
109 110 Mute/unmute clix level**
110 111 Mute/unmute all play tracks***
** The single channel mute/unmute action works as follows: If the channel’s level is greater than zero when the
command is received then the channel will be muted. If the channel's level is zero when the command is
received then the level will be set either to that of 2880’s panel fader or to that of the last CC message (20..24),
depending on which was the last received.
*** When a mute/unmute all-play-tracks command is received all play tracks will be muted if ANY of them is greater
than zero. If ALL of them are zero then each will be set to fader or CC level.
MIDI Out (MIDI Thru):
2
880 generally relays all received M
I
DI messages at its MI
DI out connector. But in Internal sync mode it does not
relay the sequencer commands: STOP START CONT CLOCK.
26
To Next Page
Loading...
