4
MULTI – Multi-tap delay – In this mode, each repeat of the delayed signal
occurs at exactly the same volume. The FEEDBACK knob sets the total
number of constant-volume repeats.
REVRS – Reverse delay – Echoes will play back in reverse. This is an
intelligent reverse echo: it studies your playing so that it can produce
reversed echoes that best suit your delay time setting.
Tip: Use the
CANYON’s Secondary Knob Mode to adjust the sensitivity of the intelligent
pluck detection algorithm.
DMM – Deluxe Memory Man – This is a faithful emulation of the tone of
the EHX Deluxe Memory Man bucket brigade analog delay pedal. Organic
echoes transform as they repeat, and lush modulation is available using
the Secondary Knob Mode.
TAPE – Tape delay – This mode simulates the prized analog tape echo
units of the 1970s. Echoes degrade and distort as they repeat, as tape
Wow and Flutter provide true tape character.
VERB – Reverb plus delay – In this mode, each echo also has plate reverb
applied to it.
Tip: Turn FEEDBACK all the way down to get a pure reverb
effect, where DELAY controls the pre-delay of the reverb.
OCT – Octave delay – In this mode, each repeat is progressively pitch
shifted up one octave.
Tip: A sub-octave is also available by using the
CANYON’s Secondary Knob Mode.
SHIM – Shimmer – This mode creates a shimmer effect, generating a rich
octave-shifted wash of harmony with your guitar. The CANYON achieves
this by modeling a chain of four EHX pedals:
S/H – Sample and Hold – This mode senses guitar plucks, and repeats
them indefinitely until another pluck is sensed. In this mode, the
FEEDBACK knob controls the CANYON’s sensitivity to guitar plucks. At the
To Next Page
Loading...
