Electro-Voice Eliminator - Technical Specifications

Technical Specifications: S1200, S900, Q44, Q66, Force, Eliminator, Altec Lansing 8140 & 8160
Amplifier at rated conditions, both channels driven with 8Ω loads, unless otherwise specified.
S900 / Q44 /
Altec Lansing 8140 /
Force
S1200 / Q66 /
Altec Lansing 8160 /
Eliminator
Load Impedance
8Ω 4Ω 2Ω 8Ω 4Ω 2Ω
Maximum Midband Output Power
THD = 1%, 1kHz
280W 450W 650W 380W 600W 850W
Rated Output Power
THD < 0.2%, 20Hz ... 20kHz
230W 350W 450W 300W 500W 650W
Max. Single Channel Output Power
Dynamic-Headroom, IHF-A
340W 640W 720W 460W 880W 950W
Maximum Bridged Output Power
THD = 1%, 1kHz
900W 1300W ------ 120W 1700W ------
Maximum RMS Voltage Swing
THD = 1%, 1kHz
56V 64V
Voltage Gain
at 1kHz
34dB 35dB
Slew Rate
at 1kHz
25V/µs 30V/µs
Power Consumption
at 1/8 maximum output power @ 4Ω
690W 870W
Input Sensitivity
at rated output power @ 4Ω, 1kHz
0dBu (775mV)
THD at rated output power,
MBW = 80kHz, 1kHz
< 0.05%
IMD-SMPTE
60Hz, 7kHz
< 0.08%
DIM30
3.15kHz, 15kHz
< 0.03%
Crosstalk
ref. 1kHz, at rated output power
< -80dB
Frequency Response
-1dB, ref. 1kHz
13Hz ... 45kHz
Power Bandwith
THD = 1%, ref. 1kHz, half power @ 4Ω
10Hz ... 50kHz
Input Impedance
20Hz ... 20kHz, balanced
20kΩ
Damping Factor
at 100Hz / 1kHz, 8Ω
> 300 / > 200
Signal to Noise Ratio
A-weighted
103dB
Power Requirements
240V, 230V or 120 V, 50Hz ... 60Hz
Protection
Audio limiters, High temperature, DC, HF, Back-EMF,
Peak current limiters, Inrush current limiters, Turn-on
delay
Cooling
Front-to-rear, 3-stage-fans
Safety Class
I
Dimensions
(W x H x D), mm
483 x 132.5 x 385.5
Weight
15kg 16kg