Electro-Voice ZXA1 Series - Page 16

16 en | Amplifier controls ZXA1 Series Loudspeaker
2022-06 | 06 | F.01U.218.487
User manual
Electro-Voice
Control Function
XLR OUTPUT
XLR output connector to send the signal to
another speaker or subwoofer.
POWER
AC switch for switching the ZxA1-Sub’s
power ON or OFF. The LED lights after
turning the power ON. If the LED is not lit
upon turning the power on, make sure the AC
cord is correctly connected and the outlet is
properly working.
MAINS IN
AC connection is established via an IEC-
connector. A 10ft (3m) long AC cord with
fitting IEC-plug is supplied.
Table4.2: ZXA1-SUB amplifier controls