Technical Support - A.D.L. 6/83 599 74 12-51 Rev.00
2 WARNINGS
Before starting work on a piece of equipment, check that the earth in the lodgings is working
properly by using an appropriate tool and follow the instructions described / illustrated on the
Electrolux Learning Gateway portal
http: / / electrolux.edvantage.net
When the work is finished check that the equipment’s safety conditions have been reinstated, as
though it were straight off the assembly line.
In the event of handling / replacing the electronic circuit board, use the ESD (Cod. 405 50 63-95 / 4)
kit to avoid electrostatic discharges damaging the electronic circuit board see S.B. Nr. 599 72 08-09.
Any work on electrical appliances must only be carried out by qualified technicians.
This platform is not fitted with an ON / OFF switch. Before you access internal components, take the
plug out of the socket to disconnect the power supply.
When replacing the heating element, replace it with one that has
the same characteristics (2 thermal fuses) in order not to
compromise the safety of the appliance
Do not remove / switch the NTC sensors between heating
elements.
Always empty the appliance of all the water before laying it on its side.
When replacing components, please refer to the code shown in the list of spare parts relating to
the appliance.
To Next Page