Installation Instructions42
Installation Instructions
1 Attention: The new appliance may only be installed and connected by a regis-
tered expert.
Please comply with this. If you do not, any damage resulting is not covered by
the warranty.
1 Safety information for the installer
• The electrical installation is to be set up so that the appliance can be isolated
from the mains with a minimum 3mm all-pole contact separation.
Suitable separation devices include e.g. cut-outs, fuses (screw fuses are to be
taken out of the holder), RCD’s and contactors.
• Anti-shock protection must be provided by the installation.
• The built-in unit must meet the stability requirements of DIN 68930.
To Next Page
Loading...
