Electrolux Combi TOUCH Series - Page 58

58
Anom-
aly
Type of
anomaly
Description
Possible causes Actions
ACF Warning Air filter absent
• Filter not detected;
• Possible damage to inter-
nal electric and electronic
components due to air
filter absence.
• Refit the filter;
• If the problem persists call Service.
ACUM Stops oven Main electronic board
not identified
Communication problem
with the main electronic
board.
• Switch the oven OFF/ON;
• If the error persists, call Service.
ASCH Warning Component compart-
ment temperature
warning
• Filter is dirty;
• Too high room
temperature.
• Check room temperature considering the
oven needs fresh air to cool electronic
compartment.
• Clean the filter;
• Allow oven to cool before cooking;
• If the problem persists, call Service
BEtc Stops
cleaning
Error, excessive time
on closing operation
during cleaning
Mechanical or electrical
problem with vent valve.
Call Service
BEto Stops
cleaning
Error, excessive time
on opening operation
during cleaning
Mechanical or electrical
problem with vent valve.
Call Service
BEtr Warning Boiler excessive tem-
perature raising time
The oven has detected a
low performance in the
boiler.
• It is possible to cook. Verify the cooking
results.
• If the warning persists call Service.
Bhtc Warning Warning on excessive
time on closing
operation
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
Bhto Warning Warning on excessive
time on opening
operation
• Flap (venting valve)
motoreducer or micro
switch failure.
• Obstruction at the vent-
ing valve inlet.
It is possible to continue using the oven. Cooking
results maybe different from usual.
• With the oven OFF and cold, check if any
obstruction at the ventilation chimney on the
top of the oven: remove the obstruction if any;
• If the problem persists, call Service.
bntC Stops
boiler
Boiler SSR NTC failure
(NTC4)
Temperature sensor issue. The oven has detected a problem with boiler
operation.
• Verify cooking results.
• If the problem persists, call Service.
BoLt Stops cycle
(if the cycle
needs the
boiler)
Boiler water loading
timeout
• Water supply (pressure/
quality of water).
• Electric insulation prob-
lem with water level
sensors.
• Check if the water supply is open;
• Check if the water pressure is not too low;
• Verify if the water filter is clogged. Clean it or
replace it;
• Mechanical problem with boiler operation. If
the problem persists call Service.
BSHt Warning Boiler SSR NTC
(NTC4) high
temperature
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.