Electrolux Combi TOUCH Series - Page 59

59
Anom-
aly
Type of
anomaly
Description
Possible causes Actions
BSOt Stops
cooking
cycle
Boiler SSR NTC over-
temperature (NTC4)
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine,
• Steam/Heat leakage in
the electronic
compartment.
The oven can continue to work in recovery
mode: cooking cycles will not use the boiler.
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.
Cdo Stops
cleaning
Cleaning drawer
absent
• The cleaning drawer has
not been inserted or
properly inserted in its
housing;
• The detection devices
(magnet/magnetic reed)
have issues.
The oven can continue to cook but cleaning
cycle could not be performed until the drawer will
be in place;
• Ensure that the cleaning drawer is in its
housing and inserted properly in order to
trigger the detection devices;
• If the error persists, clean the oven manually
and call Service.
CFbL Warning Cooling fan failure
• Cooling fan motor over-
load due to dirt or
oxidation
• Other electrical/mechani-
cal issue
The oven will be operative until the electronic will
reach the critical temperature.
Call Service
CntC Stops
cooking
Cavity SSR NTC fail-
ure (NTC3)
• Connector failure;
• NTC sensor failure;
• PCB failure;
• Restart the oven;
• If the error persists, call Service.
CPUA Stops oven ACS micro does not
communicate
PCB failure.
• Restart the oven;
• If the error persists, call Service.
CPUt Stops oven TC micro does not
communicate
PCB failure.
• Restart the oven;
• If the error persists, call Service.
CSHt Warning Cavity SSR NTC high
temperature (NTC3)
• Inlet air filter dirty;
• Cooling fan failure,
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
• Do not switch the oven Off;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call Service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.
CSOt Stops
cooking
cycle
Cavity SSR NTC over-
temperature (NTC3)
• Inlet air filter dirty;
• Cooling fan failure;
• Cooling inlet air sucking
warm/hot air;
• Oven installed by hot
machine;
• Steam/Heat leakage in
the electronic
compartment;
The oven can continue to work in recovery
mode: cooking cycles will not use the boiler.
• Do not switch the oven OFF;
• Wait for the temperature to decrease;
• Clean the inlet air filter;
• Check with a thin strip of paper whether a
consistent air flow can be detected at the
cooling air inlet: if not, call service;
• Check if the inlet cooling air may be affected
by heat produced in the kitchen (in case the
oven is located by hot appliances, stop work-
ing with those appliances and inform
Service);
• If the error persists, call Service.