Electrolux e:line EOEM61CS - Delayed Start, Timer, and Other Clock Features

Setting the delayed start cooking time
The “cook time” and “stop time” functions can be
combined to switch the oven on and off at a specific time
during the day.
1. Select the desired oven function and cooking
temperature.
2. Press “CLOCK” as often as necessary, until the “cook
time” ❘➔❘ symbol appears.
3. Set the desired cooking time by using – or + , whilst the
“timer arrow” ❘➔❘ symbol is ashing.
4. Press CLOCK as often as necessary, until the “end
time” ➔❘ symbol appears ashing
5. Set the desired switch-off time using the – or + whilst
the ❘➔❘ symbol is ashing. The “cook time” ❘➔❘ and “end
time” ➔❘ arrows are lit to confirm that the oven has
been programmed.
Note:Delayedstartcookingtimecannotbesetforthe
RapidHeatfunction.
Setting the timer
1. Press TIMER button until the display begins to ash.
2. Set the countdown time you want by using – and +.
Commence with setting the number of seconds first.
The minutes and hours can then be set by subsequently
pressing the TIMER again and adjusting using the – and
+ buttons. 5 seconds after the last change the timer will
stop ashing, conrming the timer has been set.
3. To cancel the timer press the timer button until the
display ashes. Then press and hold + and – buttons
until the timer is cleared.
4. To stop the beeper, press –, + or TIMER buttons
Note:Theclockdisplaycannotbeselectedwhenthetimer
isoperating.
Elapsed Time
When an oven function is selected (other than pyrolytic
clean) and elapsed timer commences on the display
1. To reset this timer press and hold both the + and –
buttons until the timer is reset.
Displaying the cavity temperature
1. During operation of the oven the current oven
temperature during pre-heating of the oven can be
displayed by pressing the TEMP button. During normal
operation the set temperature can be reviewed by
pressing the TEMP button.
Note:thistemperaturewillonlybedisplayedfor
approximately5seconds.
Light operation
1. During operation of the oven the lamp can be switched
off by pressing and holding the TIMER button until the
light turns off. Also the light can be turned on from the
standby state by pressing and holding the TIMER button
until the light comes on.
Model EPEM61CS Electronic Clock
18 additional functionality – electronic control oven electrolux e:line ovens