Electrolux EBC54524 - Page 19

19
ENGLISH
FOR CAPPUCCINO”.
18.10 Programming the jug
For instructions on programming the
jug, see the section “ CHANGING JUG
FUNCTION PARAMETERS”.
18.11 Programming water
For instructions, see the “CHANGING
THE QUANTITY OF HOT WATER” sec-
tion.
18.12 Descaling
IMPORTANT! Descaler contains
acids.
Respect the safety warnings
provided by the manufacturer and
given on the descaler pack.
Use the descaler recommended
by the manufacturer only.
Use of other descalers invalidates
the guarantee.
Failure to descale the appliance
as described also invalidates the
guarantee.
When “PLEASE DESCALE !” is dis-
played, the machine requires descaling.
Proceed as follows:
• makesurethemachineisready;
• Pressthe icon (B2) to enter the
menu and then the icons (B7)
and (B8) until “DESCALE” is displayed.
• PresstheOKicon(B9)andtheap-
pliance displays “DESCALE PLEASE
CONFIRM”.
• PresstheOKicon(B9).Themessage
“ADD DESCALER PLEASE CON-
FIRM” is displayed.
• Emptythetankofwater,pourthe
contents of the descaler bottle into the
tank respecting the instructions given
on the descaler pack, then add water.
Position a container with a capacity
of about 2 litres under the hot water
spout.
• PresstheOKicon(B9).Descalerflows
out of the hot water spout into the
container below.
The appliance displays: “DESCAL-
ING”.
• Thedescaleprogrammeautomatically
performs a series of deliveries and
pauses.
• Afterabout30minutes“DESCALE
COMPLETE PLEASE CONFIRM” is
displayed.
• PresstheOKicon(B9).“RINSING
FILL TANK” is displayed.
• Emptythewatertank,rinsetoelimi-
nate descaler residues, then fill with
clean water.
• Replacethetankfullofcleanwater.
“RINSING PLEASE CONFIRM” is
displayed again.
• PresstheOKicon(B9)again.
Hot water flows out of the spout into
the container below and “RINSING” is
displayed.
• Waituntil“RINSINGCOMPLETE
PLEASE CONFIRM” is displayed.
• PresstheOKicon(B9).“DESCALE
COMPLETE” is displayed, then “FILL
TANK!”. Fill the tank again with clean
water.
• Thedescaleprogrammeisnowter-
minated and the appliance is ready to
make coffee again.
NOTE: If descaling is interrupted be-
fore completion, the process must be
begun again from the beginning.
IMPORTANT! FAILURE TO
DESCALE THE APPLIANCE
REGULARLY INVALIDATES THE
GUARANTEE
18.13 Resetting default values
(reset)
If you change the original values, the
default values can be reset as follows:
• Pressthe icon (B2) to enter the
menu and then the icons (B7)
and (B8) until “RESET TO DEFAULT”
is displayed.
• PresstheOKicon(B9)andtheappli-
ance displays “RESET TO DEFAULT
PLEASE CONFIRM”.
• presstheOKicon(B9)toresetthe
default values;