Electrolux EBC54524 - Programming Coffee

18
19www.electrolux.com
(B9) to confirm.
• Usethe icons (B7) and (B8) to
set the minutes, then press the OK
icon (B9) to confirm.
• Pressthe icon (B6) to exit the
menu.
18.5 Setting auto-start time
This function programmes the time the
machine will come on automatically.
• Makesuretheclockontheappliance
has been set.
• Pressthe icon (B2) to enter the
menu and then the icons (B7)
and (B8) until “START TIME” is dis-
played.
• PresstheOKicon(B9).
• Usethe icons (B7) and (B8) to
set the auto-start time, then press the
OK icon (B9) to confirm.
• Usethe icons (B7) and (B8) to
set the minutes, then press the OK
icon (B9) to confirm.
• Pressthee icons (B7) and (B8)
to activate the auto-start function until
“AUTO START” is displayed.
• PresstheOKicon(B9)toconfirm.
“AUTO START PLEASE CONFIRM” is
displayed.
Press the OK icon (B9).
The symbol appears on the display.
• Pressthe icon (B6) to exit the
menu.
• Todisableauto-start,pressthe
icon (B2), then the icons (B7)
and (B8) until “AUTO START” is
displayed. Press the OK icon (B9).
“PLEASE CONFIRM” is displayed.
Press (B6) to disable, the
symbol disappears.
18.6 Changing coffee
temperature
To change coffee temperature, proceed
as follows:
• Pressthe icon (B2) to enter the
menu and then the icons (B7)
and (B8) until “TEMPERATURE” is
displayed.
• PresstheOKicon(B9).
• Pressthe icons (B7) and (B8) to
select the required coffee temperature
from low, medium and high.
• PresstheOKicon(B9)toconfirmthe
temperature selected.
• Pressthe icon (B6) to exit the
menu.
18.7 Setting water hardness
The operating period can be extended if
required, making descaling less frequent
by programming the machine on the
basis of the real lime content in the water
used.
Proceed as follows:
• removethe“TotalHardnessTest”strip
(attached to page 2) from its packaging
then dip it fully in the water for a few
seconds.
Then remove and wait about 30 sec-
onds (until it changes colour and forms
red squares).
• turntheapplianceonbypressingthe
ON//stand-by button (A7).
• Pressthe icon (B2) to enter the
menu and then the icons (B7)
and (B8) until “WATER HARDNESS” is
displayed.
• PresstheOKicon(B9).
• Pressthe icons (B7) and (B8)
until the number coincides with the
number of red squares on the test strip
(for example, if there are 3 red squares
on the test strip, select the message
“WATER HARDNESS 3” .
• PresstheOKicon(B9)toconfirm.
The coffee maker is now programmed
to provide the descale warning when
actually necessary.
18.8 Programming coffee
For instructions on programming coffee,
see the “CHANGING THE QUANTITY
OF COFFEE IN THE CUP” section.
18.9 Programming cappuccino
For instructions on programming cap-
puccino, see the section “CHANGING
THE QUANTITY OF MILK AND COFFEE