Sequence draining with pressure switch level check
T2
(variable)
T3
(variable)
T1
(variable)
1 draining sequence
with variable timing
level check!
.
New draining with sequence draining
- The draining step contains of 3 time sequences.
In the middle sequence, during time T2 the drain pump is stopped.
- At the end of the drain step, the water level is checked.
- If the switch back is reached, the drain step is terminated.
If the switch back isn’t reached, the drain step is repeated.
- A failure code is displayed, if after 2 drain steps, the switch
back couldn’t be reached.
In this case, the program is stopped.
19
drain pump
on
off
Drain Cycle T1 T2 T3
First draining before every wash cycle 45 sec 15 sec 20 sec
Draining after the wash cycles 30 sec 20 sec 10 sec
To Next Page
Loading...
