6.2. General information
l
Equipment in the panel area
(see description page B1)
Possible equipment:
w
Separate ON/OFF switch S0
without optical confirmation.
w
6 keys S1
to S6 to select programs or options with the corresponding LEDs
All keys are free and can be programmed without any restriction by the programming of the appliance variant.
w
6 LEDs (LD7
to LD12) for SZV, PAA etc.
Keys S0 (ON/OFF) and the first 3 keys S1 to S3 with the corresponding LEDs and the "END" LED.
The keys S1
to S3 are absolutely necessary to select all customer respectively service functions, such as setting of hardness!
l
Variant-depending existing equipment:
w
3-step start-time preselection with display by LEDs LD7
to LD9
The time steps are 3h - 6h - 9h
w
LED display for salt
w
LED display for rinse-aid
w
LED display for END
l
Functions which can be adjusted variably by the customer via the control panel:
(see description page B 11-13)
w
display and alteration of water hardness by coded flashing of "END" LED
w
Switching on/off of rinse-aid addition. Display by coded flashing of the "END" LED
w
Switching on/off of signal sound "END". Display by coded flashing of the "END" LED
l
Miscellaneous:
w
regeneration depending on need
w
manufacturing test routine
w
several service functions (fault memory, single actuator selection, ...)
w
alternatively with or without fan drying
w
aqua control system in different versions
depending on electr. and mech. components and the corresponding variant programming
l
Possible selectable program options:
w
start-time preselection
w
half load "small quantity" as automatic system or with key
w
additional washing cycle
w
3 in 1 (special tablet program)
w
senitize
EDW 1003 / VGA
LD1 LD2 LD3 LD4 LD5 LD6
S1 S2 S3 S4 S5 S6
LD7
LD8
LD9
LD10
LD11
LD12
S0
21
To Next Page