• Open the ducting carriage.
• Remove the metal grease filters one at a
time, releasing the fasteners provided.
• Close the ducting carriage.
• Insert the Hood until it connects with the
snap-on side Supports. (fig.8)
• Open the ducting carriage.
• Lock it in position by tightening screws Vf
from underneath the Hood. (fig.8)
• Should it be necessary to make adjustments
to the inside of the filter holder element,
proceed as follows:
• Loosen the four adjustment screws Vr
and close the carriage again. (fig.9)
• Move the whole filter holder element un-
til it is properly aligned with the wall-
mounted unit. (fig.10)
• Holding the hood canopy still, extract the
carriage and tighten the adjustment
screws Vr. (fig.9)
• It is now possible to fasten the hood to the
wall-mounted unit using the screws 12a
(3.5 x 16) provided. (fig.11)
• Replace the metal grease filters.
• Close the ducting carriage.
To Next Page
Loading...
