22
properly placed as shown in the diagram.
In order to place the pan supports in the
proper way, make sure that the longest arm
of the pan support is positioned in
correspondance with the hole placed at the
base of the burner as shown in the picture.
This way, the pan support will be stable and
fixed.
Pay attention when replacing the
pan supports in order to avoid
scratching the glass hob top.
The Burners
Frequently wash the burner caps and
crowns using hot soapy water and remove
marks with a mild paste cleaner. A well
moistened soap impregnated steel wool
pad can be used with caution, if the marks
are particularly difficult to remove. For
stubborn stains, use normal non-abrasive
cleaners or specific products available on
the market. NEVER use scouring pads,
steel wool or acids for cleaning.
The ignition system
The electric ignition is obtained through a
spark plug containing a metal electrode
(letter C). Keep these components clean,
to avoid difficult lighting, and check that the
burner crown holes are not obstructed.
Ensure that the condition and efficiency of
the gas pipe and any pressure regulator are
periodically checked. If any anomalies are
detected, do not ask for repairing but always
have the part replaced.
Periodical maintenance
A - Burner cap
B - Burner crown
C - Spark plug
D - Thermocouple
To Next Page
Loading...
