31
Minimum flame adjustment
If it is necessary to adjust the minimum
flame setting, proceed as follows:
1. Carry out the steps described in the
paragraph “Setting the hob for the new
gas type” - points 1, 2, 3, 4 and 5.
2. Light the burner to be adjusted by
touching the Burner Ignition Control .
The burner lights at the maximum flame
level and, after a regular flame is
obtained, it sets at the minimum flame
level .
3. If the minimum level is too low or not
satisfactory to maintain the burner lit,
touch the Increasing or Decreasing
Control to carry out a fine
adjustment (visual check).
4. Switch off the hob touching the main
ON/OFF Control .
To Next Page
Loading...
