30
5. Touch the Decreasing Control to
select the required type of gas.
6. After selecting the type of gas, switch
off the hob touching the main ON/OFF
Control .
7. Touch the main ON/OFF Control
again to reactivate the hob.
The appliance is automatically set to the
normal “User Mode”.
8. Light all the burners and adjust their
flame to minimum, in order to check the
flame stability (visual check).
9. At the same time, check the flame
aspect (visual check).
If both the flame stability and the flame
aspect are satisfactory, the setting of the
hob for the new gas type is completed.
If the flame stability is not satisfactory, carry
out an additional adjustment as described
in the following paragraph.
To Next Page
Loading...
