29
Setting the hob for the new
gas type
1. If necessary, activate the top by touching
the main ON/OFF Control for about
3 seconds.
2. Touch the Timer Control repeatedly
to select the auxiliary burner (front left
burner) on the burner selection display.
3. Touch the Increasing Control and
hold the finger on it until the value 99
appears on the time display. Then, touch
the Decreasing Control and hold
the finger on it until the value 80 is
displayed.
4. Then, touch the Increasing Control
until 83 is displayed. At this point, the
hob is set to the “Gas Change” mode
and the current gas setting appears on
the display:
- n0 stands for gas G20 (20 mbar)
- n1 stands for gas G30/G31 (30 mbar)
- n2 stands for gas G20 (13 mbar)
To Next Page
Loading...
