35
J7 Alarms
In case of a generic dishwasher fault, the display
shows the relevant alarm code.
For example:
List of possible documented machine alarms with
respective cause / cure.
(*) When the display shows alarm A1, the "water
tap" indicator also lights up ("E" -
Table 2 "Control
panel").
J8 Hood type dishwasher with incorporated
continuous water softener
These models have a continuous softener in the
dishwasher water circuit. By means of special resins,
this device removes the calcareous substances from
the feed water, supplying decalcified water for
washing.
For the continuous softener to work properly the resins
must be regenerated periodically, with frequency
depending on the hardness of the water and the num
-
ber of wash cycles carried out.
Unlike conventional water softeners, this continuous
softener does not require machine stops for regenera
-
ting the resins.
AUTONOMY OF THE FULL SALT CONTAINER
ACCORDING TO THE CHANGE IN INLET WATER
HARDNESS
Salt container
The water can only be softened if there is salt in the
special container. The salt container must be filled
when the dishwasher is started the first time and
whenever the message
appears and an
audible alarm sounds.
No salt in the container
When the salt container is empty, the message
appears on the display and an audible alarm
sounds. Wash cycles can be started just the same,
even if the display signals no salt; in which case the
water used for washing is not softened.
How to fill the salt container
• Raise the hood (with an automatic appliance, by
pressing the open/close button “B/C” -
Tabl e 2
“Control panel”).
• Switch off the dishwasher by pressing button “A”
(
Tabl e 2 “Control panel”).
• Unscrew cap "A" (Figure 28) of the salt container,
turning it anticlockwise.
Code Description Cause / Solution
A1 (*) NO WATER Check that the cock is open.
Check that the water inlet filter is
clean.
Check the minimum mains
pressure.
Check that the overflow pipe is
inserted.
B1 INEFFICIENT
DRAINAGE
Check if the overflow has been
removed.
Check for obstruction on the
waste outlet pipe and the
overflow aperture.
B2
TANK WATER
LEVEL TOO
HIGH
Check for obstruction on the
waste outlet pipe and the
overflow aperture.
C1..C9
CALL THE
SERVICE
CENTRE
E1..E8 CALL THE
SERVICE
CENTRE
The appliance continues to
operate, but appropriate checks
by a technician are
recommended.
F21..F22 CALL THE
SERVICE
CENTRE
A 1
Water hardness
The salt container
must be filled
approximately
every (*):
Using cycle 2 for 30
cycles/day, the salt
container must be fil
-
led approximately
every (*):
°f °d °e Cycles Days
15 8,4 10,6 2700 90
20 11,2 14 2180 73
25 14 17,6 1575 53
30 16,9 21,1 1035 35
35 19,7 24,6 855 30
40 22,5 28,1 675 23
45 25,2 31,6 450 15
50 28,1 35,1 270 9
(*) Considering a rinse time according to the factory settings.
IMPORTANT:
Only use coarse salt with a purity level of
99.8% NaCl. The use of salt with a lower
purity level can cause clogging of the salt
container filter and malfunctioning of the
water softener.
To Next Page
Loading...
Need help?
General
