Electrolux EHT8IUSPH6 User Manual

37
ENGLISH
5. Lift the hood again by pressing button "B" to
remove the tank filter "3".
6. Close the hood and select again the drain cycle
by pressing button "M".
7. At the end of the drain cycle, remove and clean
the pump suction filter "4".
• The message "CLE" ("CLEAN") will be displayed
throughout the drain cycle:
• After a few minutes, 3 beeps indicate the end of
thecleaning cycle and “END” blinks on the display:
• Switch off the dishwasher by pressing button “A”
(
Tabl e 2 “Control panel”).
• Switch off at the mains.
• Close the water supply cock.
• Replace the filter and the overflow (Figure 31).
.
Cleaning the nozzle jets
• Remove the upper and lower wash arms "F" and
rinse arms "I", undoing the ring nut "H" (
Figure 32).
• Carefully clean the washing and rinse jets and
clean everything with hot water and neutral deter
-
gent/detersive, if necessary using a soft brush or
sponge. Do not use sharp implements to clean the
nozzle holes, which could otherwise be damaged.
Upon completion of cleaning operations, replace the
parts removed previously.
J9.2 Exterior cleaning
Before carrying out any cleaning operations, turn off
the power at the mains.
IMPORTANT
Clean the stainless steel surfaces using warm
soapy water; never use detergents containing
abrasive substances nor steel scrapers, common
wire wool, brushes or scrapers; rinse thoroughly
using a wet cloth and carefully wipe dry.
Clean the control panel using a soft damp cloth
and a neutral detergent if necessary.
Do not wash the appliance using direct or high-
pressure water jets.
To reduce the emission of pollutants into the environ-
ment, clean the appliance (externally and where
necessary internally) with products having a biodegra
-
dability of over 90%.
Leave the hood raised whenever the appliance is not in
use.
J10 Long idle periods
Whenever the dishwasher is not going to be used for a
long period of time (e.g. one month), carefully carry out
the following instructions.
• Close the water supply cock.
• Completely drain the tank.
• Remove and carefully clean the filters.
• Completely drain the incorporated dispenser
hoses, removing them from the containers. Repeat
the procedure described in the paragraph “Manual
activation” at least 3 times.
• Completely drain the boiler.
• Clean the inside and outside of the machine as
indicated in par. J9.1 “End of service and daily
internal cleaning” and J9.2 “Exterior cleaning”.
• Spread a film of paraffin oil over the steel surfaces.
Figure 30 Filters and overflow
Figure 31 Filters and overflow
1
B
2
3
3
4
2
1
A
CLE
End
3
B
2
1
2
1
3
4
A
3
1
C
Figure 32 Wash and rinse arms
H
I
F

Electrolux EHT8IUSPH6 Specifications

General

Brand	Electrolux
Model	EHT8IUSPH6
Category	Dishwasher
Language	English